![]() ![]() If the entire engine is restricted disassembly of the entire engine block may be necessary. Inspect the oil passages to the Solenoids and from the Solenoids to the lifters. Remove the each pair of lifters for Cylinders 4 and 6. Remove the Bank 2 per Service Information. Remove both Solenoids on Bank 2 of the engine block. If the passages are not clogged with debris, replace the MDS Solenoid 6.ġ. If the passages are unable to be cleaned out, replacing the engine block may be necessary. If the passages are restricted, clean the passages and replace the MDS Solenoid 6. Remove the Solenoid and check for any debris that may be blocking the oil passages to the Solenoid. ![]() With the scan tool actuate the MDS Solenoid 6. NOTE: The DTC must not be active for the actuator test to operate properly, clear all DTC before continuing. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure)
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |